Universal-Bremsschlauch On-Road-Modell

I used it for extension from ABSUnit to MASTER.

Japan User(translated)

Excellent

Feb 10, 2016

I used it to attach Radial brake master to Motorcycle with ABS.
OEMHose was missing, I had to extend 5 cm.
Since it will be exchanged only above ABSUnit, air bleed etc. etc. Although it was easy, since it becomes an important part, installation - It is necessary to carry out maintenance reliably.

Frame - Wheel is BlueColor - Since the body is Silver, PlatingHose and Banjo of BlueColor are matching.

I used it for extension from ABSUnit to MASTER.

Helpful?

Japan User(translated)

Very Good

Mar 14, 2013

Since a Colorful Banjo was not liking, the attached Hose of the Rear brake having been too long, and management having been amusing and an Aluminum were also exchanged for this.Although he wanted to put in the thing of a Stainless Banjo in fact, the Plating & Smoked type here is chosen in Cost.a Plating Banjo -- I think that it is so much equal even if it compares with the beautiful Swage line which carried out and was attached from the first.Although it is just being able to say to other Manufacturers, a Straight and a thing with high prices of Fittings other than 20 degrees are difficulties.

Helpful?

Although it is minor compared with a Good ridge or an Earls something, I think that it is not efficiently inferior.First of all, since a Fitting and Banjoes were made into Aluminum specification, it is businesslike with consumable goods.

Japan User(translated)

Very Good

Jan 30, 2013

Helpful?

NO NAME

Installed on: SUZUKI GSX1300R HAYABUSA

Excellent

Nov 7, 2024

It's a good part.

I bought it with an existing Hayabusa bolt-on kit, but I bought it again because it was too short to install on a Brembo 16rcs

Easy to install and Snap, but is the exterior vulnerable to Fluid?

Helpful?

Japanese Webike user

Very Good

Jul 16, 2022

At first, I was not aware of the ACPerformance line, but when I changed the front and rear of the Grom to Brembo calipers, I decided to go with the Quantity line.:I only chose the product sold in the Set because it happened to be ACPerformance line.

Until now, I have only used Banjo adapter and Hose in one piece.
At first I was a bit confused by the separate screw type Banjo adapter and Hose, and I think I tightened the screws a bit too tight...
I didn't know how much to tighten it, so I over-tightened it and ruined it once, and had to repurchase it.

I'm going to write this much. No?" You may think that this is a good idea, but once you get used to it, on the contrary, it is very convenient when you install the device.
After fixing the Banjo adapter to the MASTER and Caliper at the desired angle, measure the distance between the two and purchase another hose of the correct length to avoid having the adapter too short or too long to handle.
I had to measure the length of the hose that was too short or too long, and then estimate the length of the hose to be just right.
In that sense, I think that having one Hose of a certain length will allow for beautiful Hose handling. I think it is a good idea to have one hose of a certain length.

However, the Hose that leaked the first Fluid is getting cloudy, partly because I didn't rinse it properly after installation, and it seems that Fluid resistance is not so good on the outside...