- I thought that aluminum would be too heavy, so I used reinforced plastic? of this one.This is a progress report on a WR250F '08 for six months of use.The product itself is thick enough to go through s...Weiterlesen
- Personally, I would give it a near perfect scoreSomething about Fitting was bad, the Review said, but Balance the Bolt If you close it well enough, it will fit!The past Reviewers have been terrible at...Weiterlesen
- HUSQVARNA 2004 WR125 does not have the skid plate on the OEM and It's hard to find Aftermarket parts, but we finally found this product! It is made in FranceAbout 6mm thick Material:It is plastic It i...Weiterlesen
- Purchased here because it was somewhat disgusting if it was a Skid plate made of Gold genus.I was aware that I read other people 's impressions, but Bolt' s Length is missing - It is iterative...Weiterlesen
- Durability and weight saving are Number one with 6 mm thick hard Polyethylene.Installation is easy, but searching for Bolt holes requires a little hang, but you can easily install it if you get used t...Weiterlesen
- It purchased by Design serious consideration.
It is dramatically easy, and it comes out strongly and > attachment is light.
However with the hezagonal wrench of an in-vehicle tool, a Screw is unfi...Weiterlesen - - Since it is the same mounting arrangement as a NORMAL, removal and attachment are dramatically easy.
A large area is covered so that and an Engine may be wrapped from the bottom.
Seemingly and t...Weiterlesen
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING