- The Radiator was dirty with mud and small pebbles etc. in the Radiator as OEM, but by installing this product on the FFender, the dirt was almost eliminated. I am satisfied with the installation of th...Weiterlesen
- Water and mud splashes are reduced and feet are less likely to get wet.After driving on a forest road, mud was accumulating and hardening near the cooling fan. After installation, the mud splashing wa...Weiterlesen
- Dirt comes up to the Radiator and Stem, so it is installed.It is more troublesome than expected because it is necessary to remove the Wheel to remove the Fender.It fits perfectly without Tape, so if T...Weiterlesen
- The Fender is now long enough that there seems to be a mud splash effect.It doesn't look that noticeable.If you can remove the front tire and work on it, I think you will have no trouble installing it...Weiterlesen
- Installation is a simple process of attaching with the included double-sided tape.Effectiveness.Small stones and mud rolled up by Front are reduced.If only it were a little longer? 5.Weiterlesen
- I purchased these to reduce mud splatter on my Horizontal TypeEngine when I bought my Grom new. I used 3M double-sided tape instead of the supplied double-sided tape for installation. It has been 7 ye...Weiterlesen
- It arrived today in the morning, no problem to check the product, I temporarily matched it to the Fender and it fits perfectly, it looks like an OEM Product, it is thick and solidly made, it is a down...Weiterlesen
- I installed it on my 2021MODEL. It is cheaply made, but I feel no problem to integrate it with Fender.We have not used it in the rain yet, but we expect it to reduce mud splashing.Weiterlesen
- I'm sure it will look bad, but it is practical. I don't have a photo of it as I don't have a vehicle at hand, but it has reduced the amount of mud splashing from stepping stones. I asked a motorcycle ...Weiterlesen
- There was a lot of bouncing off the front wheels when it was raining or there was water on the road, but after installing the Extender Fender I was pleased with the effect. It is best to remove the OE...Weiterlesen
- I installed this on my NC750X 2021.I installed it because the Fender is too short for OEM and it makes the car body dirty.It is recommended to fix it with Double-sided Tape and Pin, but since the qual...Weiterlesen
- 我的车是厂牌是本田,车型是NC750X,年份是2020年10月。我在webike上购买了P&A的前挡泥板商品,它的材质是塑料;不知道为何原车的前挡泥板这么短?安装这个延长板的时候要把原车的前挡泥板拆了,用3M胶固定,最好用3个或者4个铆钉固定好,还是不能骑太快,否则还是会甩的水箱散热板上。
----------------------------------------------
M...Weiterlesen - I installed it on the Grom.The Size of the extension is also just about right, which is nice.The reason I wanted to install this is that the NORMAL Fender is shortEven the top side of the cylinder hea...Weiterlesen
- After purchasing the Rear Extend Fender for the dirt around the R suspension, the Front was purchased because....3mm (I think it was 4mm?) The structure which makes a hole with the Drill of the "Mere ...Weiterlesen
- Radiator guard is less and more expensive, so I chose it insteadNo Gap or blur when glued together with just 3M SealHowever, it is preferable to have an environment where drilling is possible because ...Weiterlesen
- Installed in VFR800FFitting is surprisingly good (to the point where you might think it's a specialized product)Bottom line is, the bounce is down 40%. I'd say that's about itHowever, the installation...Weiterlesen
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING