[Fertig]Blau eloxiert
[Größe]M12 x 14mm x P1,5 (mit Drahtsicherungsbohrung)
[Spezifikation]mit Magnet
- Universelle Passform, die Passung wird zur Referenz-Fahrradmodellinformation.
- Dieses Produkt ist nur für Modelle mit den aufgeführten Modell- und Rahmennummern. Es kann auf keinem anderen Modell installiert werden.
- Anzugsdrehmoment beträgt 20Nm (2,0kgfm). Nicht nachziehen, wenn der Motor warm ist. Ziehen Sie die Schrauben nicht nach, wenn der Motor warm ist, da dies zu einer Beschädigung der Schrauben oder zu deren Abfallen führen kann.
- Achten Sie darauf, die Dichtungsscheibe nach jedem Ausbau zu ersetzen. Wenn es wiederverwendet wird, kann es zu Ölleckagen kommen.
- Bitte entfernen Sie bei der Installation das am Magnetteil haftende Eisenpulver und den Schmutz der Montagefläche der Gehäuseseite.
- Entfernen Sie auf keinen Fall das Ölfiltersieb. Dies soll verhindern, dass Verunreinigungen in den Motor gelangen, falls das Magnetteil abfällt.
[Finish] Blue Anodized
[Size] M12 x 14mm x P1.5 (With Wire Lock Hole)
[Specification] with magnet
- Universal fit, the fitment becomes reference bike model information.
- This product is only for model with the listed model and frame numbers. It cannot be installed on any other model.
- Tightening torque is 20Nm (2.0kgfm). Do not retighten when the engine is warm. Do not retighten the bolts when the engine is warm, as this may cause damage to the bolts or cause them to fall off.
- Make sure to replace the sealing washer after each removal. If it's reused, it may cause oil leakage.
- Please remove the iron powder adhered to the magnet part and the dirt of the mounting surface of the case side when you install it.
- Do not remove the oil filter screen by any means. This is to prevent contamination into the engine in the event that the magnet part falls off.