Excellent
The look and Impact of RearStyle has improved a lot!What made you decide to buy?
ZX-6RFender Eliminator When I searched, because there were many Active made Fender Eliminator Kit installation rates, and because the amount of information of the installation method and the Image picture after installation etc. was also large, I chose Active made Fender Eliminator Kit. In addition to that, in the Side stay part "Laser Engraving by ActiveLogo." is my favorite.
How was your experience with it?
I didn't hate the OEM Fender, but the look and impact of the RearStyle was so much better that I couldn't stop smiling after installing it. Also, the material is aluminum, so it is very light. Also, Active Fender Eliminator Kit does not come with Reflector (Reflector), so you need to buy it separately because you cannot drive on public road without Reflector (Reflector).
Also, you can rest assured that the Active Fender Eliminator Kit is a Fender Eliminator Kit that complies with the new 2021 standards.
On March 9, 2021, the Ministry of Land, Infrastructure, Transport and Tourism (MLIT) will introduce a new standard for the display of automobile license plates. The Ministry of Land, Infrastructure, Transport and Tourism (MLIT) announced on March 9, 2021 that a new standard for displaying license plates on automobiles will be applied from October 1, 2021. On March 9, 2021, the Ministry of Land, Infrastructure, Transport and Tourism (MLIT) announced that it will apply new standards for the display of license plates on automobiles from October 1, 2021. The content of the new standard to be applied from October 1, 2021 is as follows. "Up40° to down15°" and LeftRight "Quantity:Pair (for Left and Right) 0°". It is not possible to install non-standard bolt caps or frames.
[Regarding installation]
Wiring Connector(Quantity):Pair (for Left and Right) Remove the Blinker and License Plate Light. Next, remove the exhaust device (do not remove the wire) and cure it with Dustclothetc. to prevent scratches. Loosen the bolt on the body side and remove the OEM fender. When you remove the OEM Fender, be careful not to drop it and damage it! It is. Remove the OEMFender from the Quantity:Pair (for Left and Right) Remove the Blinker and transfer it to the Blinker Bracket. After that, the side stay is temporarily assembled and installed on the car body, and the balance of each bracket is taken and fastened. However, it is not reliable with the rubber sheet of the attachment because it is not planned to ride as much as possible at the time of rain. Yes! and set it to Finally, the Quantity:Pair (for Left and Right) Check the operation of the Blinker and License Plate Light, but if you do not check them after returning the exhaust device to its original state, the warning light will turn on in case of malfunction. If you do not return the exhaust device to its original state, the warning light will turn on. The work time was about 2 hours while having fun.View Detail